SPOOL AS 8E2713 - Caterpillar

Removal Procedure
Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Drain the engine oil into a suitable container for storage or disposal.
Illustration 1 g00953188
Remove bolts (2) . Remove engine oil pan (1) and the gasket.Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     8C-8422     Sealant     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g00953188
Illustration 3 g00612810
Clean the mating surface of engine oil pan (1) and the cylinder block. Apply Tooling (A) to four areas on the sealing surface of the oil pan. The areas are Marked Location (Y) . The areas are at the corners of the oil pan in the following locations:
connecting joint of the front housing and the front of the cylinder block
connecting joint of the flywheel housing and the rear of the cylinder block
Place a new gasket and engine oil pan (1) on the cylinder block.
Tighten four Oil Pan Bolts (X) .
Start with Bolt (Z) and tighten all remaining bolts (2) in a counterclockwise sequence.
Tighten bolts (2) to a torque of 31 1 N m (23 1 lb ft).
Start again with Bolt (Z) and tighten all remaining bolts in a counterclockwise sequence.
Tighten bolts (2) again to a torque of 31 1 N m (23 1 lb ft).
Fill the engine with oil to the correct level. Refer to Operation and Maintenance Manual, "Refill Capacities and Recommendations".