SPOOL 9P2347 - Caterpillar

(6) Connect a white/black wire from the 2G7204 Cable to the starting motor solenoid. Connect an orange wire from the 2G7204 Cable to the alternator. Connect pink wire (47) and dark green wire (48) to bar (49), to existing wires to the head lamps. Connect a pink wire (50) from 2G7204 Cable to bowl apron control wire (51). (7) Cut the 2G7691 Wire (52) for the scraper floodlamp and install a new connector. Connect a pink wire from 2G7204 Cable and a pink wire from 2G7203 Cable to the backup alarm switch. Install rubber grommet (53) and clips (54) as shown. Install clips (55) and clips (56). If the tractor engine is equipped with a coolant flow alarm, connect a light green wire to the switch. Connect a 2G7641 Black Wire from the air dryer (if so equipped) to a white/black wire on the 2G7204 Cable Assembly. (8) Connect two 2G7202 Cables (57) as shown and put them in position over the hitch as shown. Put all lines, cables and hoses in position in the brackets as shown on page 7 and tighten the clamps. (9) Connect cables (57) to the 2G7202 Cables that were installed earlier in the bowl side. Install a 2G7411 Guard (58) over the cables with plastic straps. Install clips (59). Install all clips and straps as necessary. (10) Install 2G7202 Cables (60) through tube (61) and clip (62) as shown. (11) Connect cables (60) to 2G7211 Bracket (22) which was installed earlier. Install the cannon plugs to bracket (22) with covers, bolts, lockwashers and nuts. Install 2G7206 Wiring Harness (63) and 2G7207 Wiring Harness (64) as shown. Install clips (65). (12) Connect white and light green wires (66) to the coolant flow switch (if so equipped) and connect a red wire to the starting motor solenoid. Connect a yellow/black wire (67) to terminal (R) and a black wire (68) to terminal (N) on fuel shutoff solenoid (69). Install a black ground wire (70) as shown. (13) Remove pressure switches (71), fittings (72) and unions. Remove the fuel gauge and oil pressure gauge. Install a 5M1065 Oil Gauge and a 8M3163 Fuel Gauge. Install two 3B7763 Coupling (73) and two 2D7325 Tee Fittings (74). Install a 5L5500 Fuel Pressure Switch (75) and a 3L6306 Oil Pressure Switch (76). Install two 5H4778 Unions (77) and again connect hoses (78). Install light switch (79) at the location shown. (14) Install the 2G7208 Wiring Harness and connect the wires to the switches as shown. Connect the gray wire from the lamp to the light switch, orange wire from light switch to heat start switch, red/white wire from the 2G7206 Harness to fuel pressure switch terminal (C), white/dark blue and pink wires from the 2G7206 Harness to fuel pressure switch terminal (NO), red/black wire from the 2G7206 Harness to the heat start switch (S) terminal, black wire from 2G7206 Harness to the