SPRING RETAI 0780144 - Caterpillar

Table 2
Serviceable Parts of the 148-8341 Connector Gp    
Qty    Part Number    Description    
1     3D-2824     O-Ring Seal    
1     6V-8713     Connector    
1     7J-9108     O-Ring Seal    Preparing the Machine for Service
Prepare the Backhoe Loader for servicing. Refer to the machine's Service Manual for all safety and operation instructions.Removal Procedures
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Remove the engine doors in order to access the radiator assembly.
Illustration 1 g00940425
Disconnect the 184-0864 Hose As that is connected to the transmission oil cooler.
Remove the 148-8347 Elbow Gp that is installed into Port (R) .Installation Procedures
Note: Use standard torque on all parts that are installed.
Illustration 2 g00940425
Install the 148-8341 Connector Gp (7) into Port (R) .
Remove four bolts from locations (M1) and (M2). The four bolts secure the hydraulic oil cooler onto the radiator.Note: The following brackets will be mounted to the radiator with the bolts that were removed from locations (M1) and (M2) .
Install the 226-9403 Bracket (6) onto the radiator. Install the 223-1460 Bracket (3) onto the radiator.
Attach the 167-1196 Cooler (2) to brackets (3) and (6) with four 8T-4200 Bolts (12) and four 5P-4116 Hard Washers (8) .
Connect the straight end of the 223-1461 Hose As (4) to oil cooler (2) with one 5D-1026 Hose Clamp . Connect the fitting end of hose (4) to connector (7) that was installed into Port (R) .
Connect the straight end of the 224-1309 Hose As (5) to oil cooler (2) with one 5D-1026 Hose Clamp (1) .
Install the 6V-9746 O-Ring Seal (10) and the 7J-9108 O-Ring Seal (11) onto the 6V-8739 Face Seal Union (9) .
Install face seal union (9) into the fitting end of hose (5) .
Connect the existing 184-0864 Hose As to face seal union (9) .
Check the transmission fluid level.
Operate the machine and check for leaks.
Reinstall the engine doors.