SPRING 0944204 - Caterpillar

4. Put hose (5) in position against the hydraulic tank and install the flanges and bolts that hold it.5. Connect five hoses (4) to the hydraulic tank in their original position.6. Install the plug in the hydraulic tank drain valve and tighten to a torque of 50 5 lb.ft. (70 7 N m).7. Install the cover under the drain valve.8. Fill the hydraulic system to the correct level.END BY: a) tilt cab forward**This operation location is in Operator's Station Disassembly And Assembly section.Disassemble Hydraulic Tank
START BY: a) remove hydraulic tank 1. Remove cap (1) from the hydraulic tank. 2. Remove gasket (2), plate (4) and ball (3) from cap (1). 3. Remove ring (5) and strainer assembly (6) from the filler tube. 4. Loosen bolt (7) and remove filter assembly (8) from the hydraulic tank. 5. Remove the two nuts that hold spacer (9) to the hydraulic tank. Remove the spacer.6. Remove seal (10) from filter assembly (9). 7. Remove nut (12) that holds screen assembly (11) to filter element (13). Remove the screen assembly.8. Use a press to put the spring under compression in the screen assembly as shown. 9. Use tool (A) to remove ring (14) from tube (15). 10. Remove spacer (16), spring (17) and valve (18) from the top of screen assembly (11).11. Remove tube (15) from the screen assembly. 12. Remove filter element (13) from cover (19). 13. Remove cover (19) from bolt (7). 14. Remove seal (21) and spacer (20) from bolt (7). 15. Remove manifold (22) and cover (23) from the back of the hydraulic tank. 16. Remove the bolts that hold cover (24) to tank (25). Remove the cover from the tank. The weight of the cover is 65 lb. (29 kg).17. Remove the two bolts and two nuts that hold flanges (28) to the base. 18. Remove two clamps (26) from the joint assembly. Remove pipe (27) and tube (29) from the tank. 19. Remove collar (30) and seal (32) from tube (29). Remove seal (31) from the tube. 20. Remove collar (33) and seal (34) from the tube assembly.21. Remove the two bolts that hold base, block and plates (35) to the tank. Remove the base, block and plates as a unit. 22. Remove seal (39) from block (37).23. Remove the two bolts and nuts that hold plate (36) and block (37) to plate (38). Remove plate (36) and the block from plate (38). 24. Remove seal (41) from base (40).25. Remove the two bolts and base (40) from plate (38). 26. Remove tube assembly (42) from the tank. 27. Remove the two nuts that hold body (43) to cover (24). 28. Remove body (43) from the tank. Remove seal (46) from the body.29. Remove guide (45) from the tank.30. Remove valve (47) and spring (44) from the guide. 31. Remove retainer (48) from the cover. 32. Remove grommet (49) and glass (50) from retainer (48).Assemble Hydraulic Tank
1. Install glass (1) and grommet (2) in retainer