SPRING GP-RECOIL 1012619 - Caterpillar

"Equipment ID"
The "Equipment ID" parameter allows the customer to enter a description into the ECM in order to identify the machine. A maximum of 17 characters can be entered in the field."Engine Serial Number"
Program the "Engine Serial Number" to match the engine serial number that is stamped on the engine information plate. The engine serial number is not preprogrammed on a replacement ECM."(FLS)" Full Load Setting
"Full Load Setting" is a number that represents the adjustment to the fuel system that was made at the factory in order to fine tune the fuel system. The correct value for this parameter is stamped on the engine information plate. Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required."(FTS)" Full Torque Setting
"Full Torque Setting" is similar to "Full Load Setting". Only change this value if the engine is rerated or if a new ECM is installed. Factory passwords are required.Parameter Table
Table 1
System Configuration Parameters    
Parameter    Available Range or Options    Default    Required Password    
"Equipment ID"     17 characters     blank     none    
"Engine Serial Number"     8 characters     blank     Factory    
"FLS"     -128 to +127     0     Factory    
"FTS"     -128 to +127     0     Factory    Parameter Worksheet
Record the following information before you change any programmable parameter.
Table 2
Engine Parameters    
"Equipment ID"    
   
"Engine Serial Number"    
   
"ECM Serial Number"    
   
"Software Group Part Number"    
   
"Software Group Release Date"    
   
"FLS"    
   
"FTS"    
   
"Total Tattletale"    
   
Table 3
Information From Engine Information Plate    
Engine Serial Number    
   
Full Load Setting
(for new ECM)    
   
Full Torque Setting
(for new ECM)    
   Note: Compare the FLS and the FTS from the ECM with the values that are listed on the engine information plate. Only change the FLS and the FTS because of a mechanical change in the engine. The use of the wrong parameters could cause damage to the engine. The use of the wrong parameters may also void the Caterpillar warranty.
Table 4
Information for Injector Trim File    
Injector    Injector Serial Number    
Injector 1    
   
Injector 2    
   
Injector 3    
   
Injector 4    
   
Injector 5    
   
Injector 6