SPRING 1474134 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Put identification marks on all hoses, on all hose assemblies, on wires and on all tube assemblies for installation purposes. Plug all hose assemblies and tube assemblies. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Turn the fuel supply to the OFF position.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g01304057
Typical example
Disconnect harness assembly (1).
Loosen hose clamps (4) and (5). Disconnect hoses (6) and (7).
Remove bolts (2) and remove electric transfer pump (3). Installation Procedure
Ensure that the electric transfer pump is clean and free from damage. If necessary, replace the electric transfer pump.
Illustration 2 g01304057
Typical example
Position electric transfer pump (3) on the mounting and install bolts (2).
Tighten bolts (2) to a torque of 9 N m (79 lb in).
Connect hoses (6) and (7). Tighten hose clamps (4) and (5).
Connect harness assembly (1).
Turn the fuel supply to the ON position.
Turn the battery disconnect switch to the ON position.
Remove the air from the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".