SPRING 1958408 - Caterpillar

Use bolts (2) to attach the mounting plates to the Product Link module (1) .
Illustration 4 g00891387
Attachment of the ground strap (D) 6V-7728 Bolt (E) 9X-6165 Washer
Place the washer (E) on top of the mounts and slide the bolt (D) through the mounts. Attach the ground strap between the nearest mounting bolt and the nearest washer.Note: If the washers are not used, the bolts will cut through the rubber mounts.
Illustration 5 g00890221
(F) 322C mounting location for the Product Link
Illustration 6 g00890222
(G) 325C and 330C mounting location for the Product Link
Illustration 7 g00909335
(H) 385B mounting location for the Product Link (J) 385B machine wiring harness
Bolt the Product Link module to the electrical relay panel. Refer to illustrations 5, 6, and 7.Note: When the Product Link module is installed, order new warning films and new decals and replace any of the warning films and decals that are covered. Place the new warning films and new decals on the machine in a nearby location. Note: Install the Product Link module so that the electrical connections are on the bottom.
Illustration 8 g00890225
View of installed antenna (3) 207-6796 Antenna Assembly
Mount the antenna (3) to the mounting bracket on the counterweight.Note: The 385B does not have an antenna bracket on the counterweight. 207-6136 Plate or 211-8490 Bracket can be used in order to install the roof mount antenna. Alternatively, 207-6798 Antenna As can be used without a mounting bracket.
Route the antenna cable to the Product Link module.
Illustration 9 g00890228
(K) 322C machine wiring harnessNote: The product link connector on the 322C S/N:BKJ
wiring harness is a male type connector. The 222-7903 Harness is designed to plug into a female connector. The product link connector on the machine wiring harness should be converted to a female connector.
Illustration 10 g00890241
(L) 325C machine wiring harness
Illustration 11 g00890242
(M) 330C machine wiring harness
Connect wiring harness (4) to the machine wiring harness (J), (K), (L), or (M) .
Illustration 12 g00890864
Connection of the wiring harness and antenna to the Product Link module (3) 207-6796 Antenna Assembly (4) 222-7903 Wiring Harness
Connect wiring harness (4) to the Product Link module.
Connect the antenna cables (3) to the Product Link module. The ends of the wires for the antenna are unique and the wires cannot be improperly connected.
Secure wiring harness (4) and antenna cables at 457 mm (18 inch) intervals.
Use tie straps to secure the wiring to the clips.
Do not route the wiring near any source of extreme heat (exhaust).
Do not route the wiring by locations that may cause abrasion.
Do not make sharp bends in the wiring.
Ensure that any excess wiring from the antenna is coiled and properly secured.Note: Do not shorten the wires for the antenna.
Turn on the machine disconnect switch.
Use a computer with the Electronic Technician software to set the hours and the configuration parameters for the Product Link module.Note: Refer to the setup procedure in Operation and Maintenance Manual, SEBU7351, "Product Link 151/201".
Check the Product Link module for proper operation.Note: Refer to Operation and Maintenance Manual, SEBU7351, "Product Link 151/201".
Install film (5)