SPRING 1S7501 - Caterpillar

Returning Equipment for Repair; Identification
If any part of the electronic control is to be returned to Woodward Governor Company for repair, attach a tag to the part with the following information: * name and location where the control is installed;* complete Woodward Governor Company part number(s) and serial number(s);* description of the problem;* instruction describing the desired type of repair.
To prevent damage to electronic components caused by improper handling, read and observe the precautions in Woodward Governor Company Manual 82715, Guide for Handling and Protection of Electronic Controls, Printed Circuit Boards, and Modules.
Packing a Complete Control
Use the following materials when returning a complete control: * packing materials that will not damage the surface of the unit;* at least 100 mm (4 inches) of tightly packed, industry-approved packing material;* a packing carton with double walls;* a strong tape around the outside of the carton for increased strength.Additional Instructions
When returning equipment to Woodward, please telephone and ask for the Customer Service Department. They will help expedite the processing of your order through our distributers or local service facility.Replacement Parts Information
When ordering replacement parts for electronic controls, include the following information: * the part number(s) on the enclosure nameplate;* the unit serial number, which is also on the nameplate.* The software part number and revision as indicated with the "ID" Key on the programmer.Address and Telephone/Telex Numbers
Use the following address when shipping or corresponding:Woodward Governor Company
Engine Controls
P.O. Box 1519
1000 E. Drake Road
Fort Collins, CO 80522-1519
TELEPHONE: (303) 482-5811 (24 hours a day)
TELEX: 4-5691
Other Service Facilities
Contact Woodward Governor Company, Customer Service Department for the name of your nearest Woodward distributor or service factility.Initial Prestart Settings
These tables are provided for the convenience of the ProAct user. Each figure should be recorded as it is programmed with the hand held programmer. Any changes should be noted so the adjustment can be referenced from its original setting.Menu 1 - Dynamics 1 Settings Menu 2 - Dynamics 2 Settings Menu 3 - Speed Reference Settings Menu 4 - Limiter Set Points Menu 6 - Configuration Set Points