SPRING GP-RECOIL 2487307 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Remove the engine side guards on the left side of the machine. Refer to Disassembly and Assembly, "Engine Side Guards - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01217803
Remove the hydraulic tank cap and install Tooling (A). Apply 276 kPa (40 psi) to 414 kPa (60 psi) of air pressure to Tooling (A) .
Illustration 2 g01217437
Disconnect hose assembly (1) .
Illustration 3 g01217442
Disconnect hose assembly (2) .
Illustration 4 g01217445
Remove four bolts (3) and remove hydraulic oil cooler (4) .