SPRING (OUTER) 2M6065 - Caterpillar

Illustration 1 g01118252
Select "File". Go to "Select ECM". Choose the "Transmission 994F" ECM.
Go to the "Service" Menu. Select "Configuration". Click "OK". Certain operations or characteristics can be changed. Oil Renewal System Parameter Screen
Illustration 2 g01159123Engine Oil Renewal System Installation Status
The Engine Oil Renewal System is a software enabled attachment. The Installation Status parameter can be set to either "Installed" or "Not installed". A factory password is required to change this parameter.Engine Oil Renewal System Enable Status
The parameter for the Engine Oil Renewal System Enable status can be changed with Cat ET. The Enable Status parameter can be set to either "Enabled" or "Disabled".Autolube Parameter Screen
Illustration 3 g01159125Autolube Interval Status
The parameter for the Autolube Interval can be changed with Cat ET. The parameter can be set to any whole minute value between "5" and "15" minutes.Minimum Autolube Pressure Configuration Status
The parameter for the Minimum Autolube Pressure Configuration can be changed with Cat ET. The parameter can be set to any value between 17.2375 MPa (2500 psi) and 20.6850 MPa (3000 psi).Reduced Rimpull Parameter Screen
Illustration 4 g01159128figure 4Reduced Rimpull Switch Position 1 Status
The parameter for the Reduced Rimpull Switch Position 1 can be changed with Cat ET. The parameter can be changed to any value between "35%" and "95%".Reduced Rimpull Switch Position 2 Status
The parameter for the Reduced Rimpull Switch Position 2 can be changed with Cat ET. The parameter can be changed to any value between "35%" and "95%".Reduced Rimpull Switch Position 3 Status
The parameter for the Reduced Rimpull Switch Position 3 can be changed with Cat ET. The parameter can be changed to any value between "35%" and "95%".Reduced Rimpull Switch Position 4 Status
The parameter for the Reduced Rimpull Switch Position 4 cannot be adjusted. The parameter for the Reduced Rimpull Switch Position 4 is fixed at "100%".Note: The Position 1 setting cannot exceed the Position 2 setting, and the Position 2 setting cannot exceed the Position 3 setting.Transmission Parameters Screen
Illustration 5 g01159129Figure 5Transmission Maximum Forward Gear Status
The parameter for the Transmission Maximum Forward Gear can be changed with Cat ET. The parameter can be set to either "2" or "3".Transmission Maximum Reverse Gear Status
The parameter for the Transmission Maximum Reverse Gear can be changed with Cat ET. The parameter can be set to either "2" or "3".CTS Enabled Status
The parameter for CTS Enabled can be changed with Cat ET. The parameter can be set to either "Enabled" or "Disabled".Lockup clutch Installation Status
The parameter for Lockup clutch Installation can be changed with Cat ET. The parameter can be set to either "Installed" or "Not Installed".