SPRING 5330811 - Caterpillar

Lifting the Power Module
The power module may be lifted by a crane from one position to another position. Two cranes are recommended to lift the power module. Using two cranes will reduce unnecessary stress on the power module. The recommended height for the hook is 6 m (20 ft).
Illustration 1 g00728446Lifting the Generator Set
Illustration 2 g06022652
Never bend the eyebolts and the brackets. Only load the eyebolts and the brackets under tension. Remember that the capacity of an eyebolt is less as the angle between the supporting members and the object becomes less than 90 degrees.When it is necessary to remove a component at an angle, only use a link bracket that is properly rated for the weight.
Do NOT use the engine lifting eyes or the generator lifting eyes to lift the entire package. Lifting points (3) have been provided on the base rails of the generator set for lifting the entire package. However, lifting the engine and the generator together requires special equipment and procedures. Consult your Caterpillar dealer for information regarding fixtures for the proper lifting of your complete package.Lifting the Engine Only
To remove the engine ONLY, use lifting eyes (2) that are on the engine.Lifting the Generator Only
Note: The control panel and the terminal box will need to be removed before attempting to lift the generator.To remove the generator ONLY, use lifting eyes (1) that are on the generator.Lifting the Clean Emission Module Only
Illustration 3 g06022360
typical example
The Clean Emission Module (CEM) should only be lifted by the designated lifting eyes (4). Lifting eye locations will be different depending on the CEM arrangement. Do not attempt to lift the CEM using straps around the diesel particulate filter. Lifting eyes are found on both sides of this system.
Do not attempt to use the radiator or CEM lift points to aid in the engine package lift.