5E2972 SPRING Caterpillar parts
AP-200
Rating:
Alternative (cross code) number:
CA5E2972
5E-2972
5E2972
CA5E2972
5E-2972
5E2972
Weight: 0.01 pounds 0 kg.
ASPHALT PAVER,
Compatible equipment models: 5E2972:
Number on catalog scheme:
33
For full view, you need register
Information:
Walk-Around Inspection
Inspect Lines, Tubes, Hoses and the Machine
Inspect Lines, Tubes and Hoses
See topic in the Safety Section "Lines, Tubes and Hoses" for the correct Maintenance Procedures.Inspect the Machine
See, "Walk Around Inspection", in the "Before Starting the Engine" section of this guide.Engine Crankcase
Measure Oil Level
Machine must be level, equipment lowered, parking brake applied, engine running at LOW IDLE or stopped. 1. Measure the oil level.2. Engine Stopped: Maintain oil level between ADD and FULL marks on dipstick.3. Engine Running: Maintain oil level between ADD and FULL marks on ENGINE RUNNING side of dipstick.Precleaner
Check - Clean if Necessary
Inspect the precleaner screen for accumulation of dirt or debris. Remove precleaner screen and clean if it is necessary.Radiator
Check Coolant Level
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
If it is necessary to add make-up coolant daily, inspect for leaks. Remove radiator cap slowly to relieve pressure. Observe coolant level. Maintain coolant level above the level indicator plate in the bottom of the fill pipe.Clean Outside of Folded Core Radiator
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.Use all cleaning solutions with care.
Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from a folded core radiator. Clean as required by condition of radiator.The use of compressed air is preferred.Refer to "Know Your Cooling System," Form SEBD0518, for the complete procedure and instructions.Fuel Tank
Drain Water and Sediment
1. Open drain valve. Allow water and sediment to drain.2. Close drain valve.If water or sediment is not present, the drain interval may be extended.Air Reservoir
Drain Water and Sediment
Drain water and sediment from both sections of the air reservoir.
Inspect Lines, Tubes, Hoses and the Machine
Inspect Lines, Tubes and Hoses
See topic in the Safety Section "Lines, Tubes and Hoses" for the correct Maintenance Procedures.Inspect the Machine
See, "Walk Around Inspection", in the "Before Starting the Engine" section of this guide.Engine Crankcase
Measure Oil Level
Machine must be level, equipment lowered, parking brake applied, engine running at LOW IDLE or stopped. 1. Measure the oil level.2. Engine Stopped: Maintain oil level between ADD and FULL marks on dipstick.3. Engine Running: Maintain oil level between ADD and FULL marks on ENGINE RUNNING side of dipstick.Precleaner
Check - Clean if Necessary
Inspect the precleaner screen for accumulation of dirt or debris. Remove precleaner screen and clean if it is necessary.Radiator
Check Coolant Level
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
If it is necessary to add make-up coolant daily, inspect for leaks. Remove radiator cap slowly to relieve pressure. Observe coolant level. Maintain coolant level above the level indicator plate in the bottom of the fill pipe.Clean Outside of Folded Core Radiator
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.Use all cleaning solutions with care.
Compressed air, high pressure water or steam can be used to remove dust, leaves and general debris from a folded core radiator. Clean as required by condition of radiator.The use of compressed air is preferred.Refer to "Know Your Cooling System," Form SEBD0518, for the complete procedure and instructions.Fuel Tank
Drain Water and Sediment
1. Open drain valve. Allow water and sediment to drain.2. Close drain valve.If water or sediment is not present, the drain interval may be extended.Air Reservoir
Drain Water and Sediment
Drain water and sediment from both sections of the air reservoir.
Caterpillar parts catalog:
Parts spring Caterpillar catalog:
9T0548
SPRING
350, 350 L, 375, 375 L, 578, 583R, 589, 910G, 933, 933C, 939, 939C, AP-200, CP-433E, CP-44, CP-56, CP-573E, CP-64, CS-433E, CS-44, CS-56, CS-563E, CS-56B, CS-583E, CS-64, CS-68B, CS-74, CS-74B, D3B, D...
350, 350 L, 375, 375 L, 578, 583R, 589, 910G, 933, 933C, 939, 939C, AP-200, CP-433E, CP-44, CP-56, CP-573E, CP-64, CS-433E, CS-44, CS-56, CS-563E, CS-56B, CS-583E, CS-64, CS-68B, CS-74, CS-74B, D3B, D...
7R6533
SPRING
AP-200, AP-200B
AP-200, AP-200B
0868468
SPRING
AP-200
AP-200
0780122
SPRING
AP-200
AP-200
0869337
SPRING
AP-200
AP-200
7R5419
SPRING
AP-200
AP-200
5E2971
SPRING
AP-200
AP-200
5E2971
SPRING
AP-200
AP-200
7R5419
SPRING
AP-200
AP-200
0869337
SPRING
AP-200
AP-200
0780122
SPRING
AP-200
AP-200
0868468
SPRING
AP-200
AP-200
0818815
SPRING
AP-800
AP-800
0868402
SPRING
PR-105
PR-105
7R2724
SPRING
PR-105
PR-105
7R2718
SPRING
PR-105
PR-105
0772944
SPRING
PR-105
PR-105
5E0950
SPRING
CB-614, PR-105
CB-614, PR-105
5E8407
SPRING-RETAINER
CB-434
CB-434