SPRING 6D0546 - Caterpillar

Function and Navigation Keys
Reference: For a full explanation of the use of the function keys and the navigation keys that are referenced in this section, refer to Systems Operation, "Electronic Control Module"
Illustration 1 g02926916
OCP Control System Panel
(1) Display screen
(2) F4 Soft key
(3) F3 Soft key
(4) F2 Soft key
(5) F1 Soft key
(6) Control key
(7) AUX overview key
(8) Engine overview key
(9) Main menu key
(10) Warning Indicator lamp (yellow)
(11) Alarm acknowledge key and silence key
(12) Shutdown Indicator lamp (red)
(13) Event reset key
(14) Event log key
(15) Run key
(16) Auto key
(17) Stop key
(18) Escape key
(19) Up key
(20) Right key
(21) OK key
(22) Down key
(23) Left key Initial Setup
Information from the OCP is displayed on the display screen (1). Press the main menu key (9) in order to get to the main menu options.Press the "OK" key (21) in order to select one of the main menu options.The keypad is also used in order to change the setpoints. Press the "OK" key (21) in order to change a setpoint. Use the navigation keys in order to increase or decrease the value. Press the left navigation key (23) or the right navigation key (20) in order to change the digit that is to be adjusted.Note: The OCP panel will power up to the "MAIN MENU" screen.Menu Maps
The maps in this section are to be used as a guide when programming the OCP. Maps are provided for all versions of the controller.
Illustration 2 g02943296Programming the Display Preferences
The preferences affect the way data is viewed on the display screen. Change the configuration as needed to meet local requirements.In order to program the display preferences, perform the following menu options.
Press the escape key (18) as many times as necessary in order to go back to the "MAIN MENU" display.
From the "MAIN MENU", press the navigation keys in order to highlight the "PREFERENCES" option. The following parameters can be changed or viewed:
CONTRAST
PRESSURE
TEMPERATURE
VOLUME
LANGUAGE
Press the "OK" key (21) in order to select "PREFERENCES". "CONTRAST" will be highlighted.
Press the "OK" key in order to select the contrast level. The contrast can be adjusted from low to high. The display will show a status bar representing the current contrast level.
Use the navigation keys in order to adjust the contrast