SPRING 6R8232 - Caterpillar

Do not disconnect any air lines until the air pressure in the system has been released.
1. Put identification on the lines for correct installation. Disconnect lines (1), (2) and (3) from the wiper switch. 2. Loosen screw (5) that holds knob (6) to the wiper switch. Remove knob (6). Remove the nut that holds the wiper switch to the dash. Remove wiper switch (4) from the back of the dash panel.3. Put the wiper switch in position in the dash from the back side. Install the nut that holds the switch in place.4. Install knob (6). Tighten screw (5) that holds the knob to the wiper switch.5. Connect lines (1), (2) and (3) to the wiper switch.