SPRING-GUIDE 7M1768 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     187-2718     Filter Wrench As     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01292695
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install valves (15), springs (14), and plugs (13) .
Illustration 2 g01292696
Install engine oil cooler (11), bolts (10), and the seals in oil filter base (12) .
Illustration 3 g01292685
Install engine oil filter base and oil cooler (9). Install bolts (8) .
Illustration 4 g01292684
Tighten the bolts to a torque of 28 7 N m (21 5 lb ft). Refer to Illustration 4 for the proper torque sequence.
Illustration 5 g01292682
Install elbow (7). Connect hoses (6).
Illustration 6 g01292680
Install tube assembly (5) .
Illustration 7 g01292686
Install elbow assembly (3). Connect hose assembly (1) and tube assembly (2). Use Tooling (A) in order to Install oil filters (4) .End By: Install the clean gas induction cooler. Refer to Disassembly and Assembly, "Clean Gas Induction Cooler - Remove and Install".