SPRING-SOLENOID 7N5628 - Caterpillar

Note: Revision 5 is now used as the Monitor Software. The Programmable Logic Controller has been updated.Note: Revision 5 will calculate the engine setpoints by using the engine rpm. The alarm setpoint and the shutdown setpoint will be calculated by the software. Refer to Engine News, SEBD9288, "Software Available for Programming Allen-Bradley Programmable Logic Controller".When a fault code is received on the "PLC Status Screen", the following information can be used in order to troubleshoot the problem.When a major fault is encountered, a hex code is written to S:6. Major faults can be one of the following types:Non-User (1) - The routine does not run.Non-Recoverable (2) - The routine runs for 1 pass.Recoverable (3) - The fault may clear S:1/13 in order to resume operation.
Table 1
Power Up Error Codes    
Code    Type    Description    
0001     1     "NVRAM Error"    
0002     1     "A hardware problem caused a watchdog alarm timeout."    
0003     1     "Memory module memory error"    
0006     3     "Reserved"    
0007     1     "Failure during a memory module transfer"    
0008     1     "Internal software error"    
0009     1     "Internal hardware error"    
Table 2
"Going to Run" Error Codes    
Code    Type    "Description"    
0010     1     "Processor does not meet required revision level"    
0011     1     "Ladder file 2 is missing"    
0012     1     "Ladder program has a memory error"    
0013     3     "Required memory module absent, or S:1/10 or S:1/11 not set (and program requires it)"    
0014     1     "Internal file error"    
0015     1     "Configuration file error"    
0016     3     "Startup protection after power loss. Error condition exists when S:1/9 is set and powerdown occurred"    
0017     2     "NAVRAM/memory module user program mismatch"    
0018     1     "Incompatible user program-operating system mismatch"    
0019     2     "Missing or duplicate label was detected"    
Table 3
"Runtime" Error Codes    
Code    Type    "Description"    
001F     1     "Program integrity error occurred during on-line revising"    
0004     1     "Memory error occurred while during run mode"    
0020     3     "A minor bit is set at the end of the scan"    
0021     1     "Remote power failure of an exposed I/O rack occurred"    
0022     2     "User watchdog scan time exceeded"    
0023     2     "Invalid/non-existent STI file number"    
0024     2     "Invalid STI interrupt interval (>2559 ms or negative)"    
0025     2     "Excessive stack depth/JSR calls for STI routine"    
0026     2     "Excessive stack depth/JSR calls I/O interrupt routine"    
0027     2     "Excessive stack depth/JSR calls for user fault routine"    
0027     2     "Excessive JSRs in the user fault routine (file 3)"    
0028     1     "Invalid/non-existent start-up protection fault routine"    
0029     3     "Indexed address outside of the data