SPRING 8G3095 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: mileage, fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Sample (Level 1) - Obtain
Coolant Sample (Level 2) - Obtain
Diesel Particulate Filter - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Fuel Tank Water and Sediment - Drain
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Water Separator - Check/Drain
Walk-Around Inspection
PM Level 1 - Every 48 000 km (30 000 miles) or 15 520 L (4100 US gal) of Fuel or 500 Service Hours
Alternator - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Grounding Stud - Inspect/Clean/Tighten
Hoses and Clamps - Inspect/Replace
Every 80 500 km (50 000 miles) or 1500 Service Hours
ARD Spark Plug - Inspect/Replace
Fumes Disposal Filter Element - Replace
Every 1500 Service Hours
ARD Nozzle - Clean
Between 24 000 and 96 000 km (15 000 and 60 000 miles)
Fuel Injector - Check
Between 24 000 and 96 000 km (15 000 and 60 000 miles) (Between the First and Fourth Oil Change)
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fuel Injector - Check
PM Level 2 - Every 320 000 km (200 000 miles) or 125 000 L (33 000 US gal) of Fuel or 4000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Coolant Temperature Regulator - Replace
Fan Drive Bearing - Lubricate
Radiator - Clean
Starting Motor - Inspect
Water Pump - Inspect
PM Level 3 - Every 483 000 km (300 000 miles) or 190 000 L (50 000 US gal) of Fuel or 6000 Service Hours or 3 Years
Compression Brake - Inspect/Adjust/Replace
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Valve Lash - Check
Fuel Injector - Check
Turbocharger - Inspect
Valve Actuators - Check
Every Year
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add