SPRING 8M8132 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance. Refer to this Operation and Maintenance Manual , "Severe Service Application" for more information.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant Extender (ELC) - Add
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Fuel System Primary Filter/Water Separator - Drain
Generator Load - Check
Generator Set - Test
Rotating Rectifier - Inspect/Test
Every Week
Automatic Start/Stop - Inspect
Battery Charger - Check
Battery Electrolyte Level - Check
Coolant Level - Check
Electrical Connections - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator - Inspect
Generator Bearing Temperature - Test/Record
Generator Lead (Flat Braided Cable) - Check
Jacket Water Heater - Check
Power Factor - Check
Space Heater - Test
Standby Generator Set Maintenance Recommendations
Every 6 Months
Coolant Sample (Level 1) - Obtain
Generator Lead (Round Cable) - Check
Every Year
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 2) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Crankshaft Vibration Damper - Inspect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Performance - Test
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Fan Drive Bearing - Lubricate
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Generator - Dry
Generator Bearing - Lubricate
Generator Set Vibration - Inspect
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Starting Motor - Inspect