SPRING 8N9594 - Caterpillar

Illustration 1 g01388037
Left side view (1) O-ring seal ... Lubricate the bore lightly with the lubricant that is being sealed. (2) Torque for the taperlock stud ... 37 5 N m (27 4 lb ft) (3) Engine oil filter assemblyApply clean engine oil on the seal. Tighten the filter until the seal contacts the base. After the seal contacts the base, rotate the filter by 180 degrees.
Illustration 2 g01388024
View A-A
Illustration 3 g01386913
Right side view (4) O-ring seals ... Lubricate the bore lightly with the lubricant that is being sealed. (5) The release control lever in the shown position allows the engine oil to flow from both the directions.
Illustration 4 g01391848
View B-B (7) Valve plunger (6) 4N-8150 Spring Length under test force ... 55.24 mm (2.175 inch) Test force ... 75.619 5.800 N (17.0 1.3 lb) Free length after test ... 93.726 mm (3.6900 inch) Outside diameter ... 20.6 mm (0.81 inch)Note: The filter bypass valve must open at the pressure difference of 255 21 kPa (37 3 psi).
Illustration 5 g01388077
Front view (8) Torque for the stud ... 37 5 N m (27 4 lb ft) (9) Torque for the taperlock stud ... 37 5 N m (27 4 lb ft) (10) O-ring seal ... Lubricate the bore lightly with the lubricant that is being sealed.