SPROCKET AS 1033599 - Caterpillar

Safety
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Illustration 1 g00104545
Prevent the machine from movement. Park the machine on a level surface.Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.Required Parts
Table 1
441-0108 Control Ar - Medium Pressure Revision -00    
Part Number    Description    Media Number    
369-9643     Auxiliary Pump and Mounting Gp     GEHS0560    
377-8219     Medium Pressure Wiring     GEHS0561    
383-9520     Front Lines Gp     GEHS0562    
383-9521     Pilot Lines Gp     GEHS0563    
383-9522     Pump Lines Gp     GEHS0564    
367-5698     Film     -    Installation
The 441-0108 Control Ar - Medium Pressure is divided into several modules. Each module has a Special instruction associated to the module. Refer to table 1. Use these Special Instructions to complete the installation of the Control Ar.Calibration
Set the machine tool control system.
ReferenceExcavator Tool Control System, UENR0446, "Testing and Adjusting