SPROCKET 2730072 - Caterpillar

Illustration 53 g02872247
Remove bolts (17) and retainer (16) .
Illustration 54 g02872253
Install shims (20) of the thickness that was recorded in Step 39 under pin assembly (19) .
Illustration 55 g02872256
Typical example
Install bolts (18) to pin assembly (19) .
Illustration 56 g02872259
Measure the gap between the bottom of pin assembly (19) and the bottom of the hitch. Record the measurement.
Illustration 57 g02869636
Install shims (15) with a thickness that is 0.25 mm (0.001 inch) less than the measured gap from Step 43.
Install retainer (16) and bolts (17) .
Illustration 58 g02867657
Use Tooling (C) in order to remove Tooling (D) from under the engine frame (6) . Remove Tooling (C) .
Illustration 59 g01118426
Remove Tooling (B) .
Illustration 60 g02864282
Connect hose assembly (10) .
Illustration 61 g02867636
Connect hose assemblies (8) and harness clamp (9) to the bracket that mounts to engine frame (6) in the articulation joint.
Illustration 62 g02867597
Install bolts (7) and the clips.
Illustration 63 g02864139
Connect harness assemblies (4) . Install all cable straps (5) that connect harness assemblies (4) to engine frame (6) .
Illustration 64 g02864018
Install panel (3) .
Illustration 65 g02864001
Install pin (2) . Repeat this step for the opposite side.
Illustration 66 g02863962
Remove retainer ring (1) . Repeat this step for the opposite side.
Illustration 67 g02722636
Remove the Tooling (A) from the hydraulic tank. Install Breather onto the hydraulic tank.
Engage the parking brake.
Remove the wheel chocks.End By: Install the middle and front drive shafts.