AVSPARE.COM
parts catalog

SPROCKET 2A0719 - Caterpillar


2A0719 SPROCKET Caterpillar parts
Rating:
26
Alternative (cross code) number:
CA2A0719
2A-0719
2A0719
Caterpillar 2A0719 SPROCKET
Weight: 0.20 pounds 0 kg.

Buy SPROCKET 2A0719 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


TERMINATION DATE
30Apr2014
PROBLEM
The existing lift arms can shift sideways on certain 563C, 573C, 2570C, and 2670C Wheel Feller Bunchers. If the lift arms shift, the pin flags can be bent.
AFFECTED PRODUCT
Model Identification Number
2570C F1B00200-00202, 204, 206-208
2670C B3E00152-00160
563C JCB00251-00270
573C RJT00250, 252-268
PARTS NEEDED
Qty
Part Number Description
4 2645246 SHIM
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 32% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Refer to the attached Rework Procedure for instructions on how to inspect and install shims if required.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-4000 hrs,
0-24 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
Move the machine to a level surface.
Inspect both the left and right side lift arms at the mounting points shown in Image1.1.1.
The maximum amount of space between the inside of each lift arm and front frame tower should not exceed 1.5mm.
If more than 1.5mm of space exists, follow the directions below in order to install up to four 264-5246 Shims, per machine. To equalize the lift arms, the same number of shims should be installed on both the left and right lift arms, or a maximum of two shims per lift arm.
Refer to KENR7577, Disassembly and Assembly, "Lift Arms - Remove and Install", Steps 9 through 11, for supporting the lift arms and removing the pins on the lift arms.
Once lift arms are secured, remove the pins only far enough to allow for the installation of the 264-5246 Shims.
Reassemble the machine. Inspect the lift arm to front frame tower gap. Ensure that less than a 1.5mm gap exists.
Image1.1.1


Parts sprocket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.