SPROCKET-TRACK 4626544 - Caterpillar

Table 2
Contact Description J2 (1)    
No. (2)    Function    Type    
2     Counter Balance Sol     On/Off    
3     Boost Sol     2A On/Off    
4     Sol Return     Load Return    
5     Counter Balance Sol 2     2A On/Off    
67     CAN Data Link +     CAN A+    
68     CAN Data Link -     CAN A-    
( 1 ) The ECM responds to an active input only when all the necessary conditions are satisfied.
( 2 ) The connector contacts that are not listed are not used.
Table 3
Contact Description Of GPS Receiver    
A     RS232 GND    
B     PWR -    
C     CAN1 LO    
D     CAN1 GND    
E     CHASSIS GROUND    
F     RS232 - 1 TXD    
G     PWR +    
H     BOOT MONITOR    
J     RS232 - 1 RXD    
K     CAN0 GND    
L     CAN0 LO    
M     ID    
N     CAN1 HI    
P     CAN0 HI    
R     RS232 - 2 RXD    
S     RS232 - 2 TXD    
Table 4
Contact Description Of GPS Radio    
A     + Battery    
B     Ground    
C     Com 2 TXD    
D     Com 2 RXD    
E     Can 0+    
F     Com 1 TXD    
G     Com 1 RXD    
H     Can 0-    
Table 5
Contact Description Of Display (3)    
A     BUZZER GND    
B     SWITCH INPUT 0    
D     +B IN    
E     +B OUT    
F     -B IN    
G     -B OUT    
J     CAN B -    
K     CAN B +    
L     CAN D +    
M     CAN D -    
N     RS232 - 2 TXD    
P     RS232 - 2 RXD    
R     RS232 SGND 2    
S     RS232 SGND 1    
T     RS232 - 1 RXD    
U     RS232 - 1 TXD    
X     BUZZER    
Y     SWITCH INPUT 1    
DD     CAN SHIELD 0    
EE     CAN SHIELD 1    
FF     RS232 - RTS 0    
GG     RS232 - CTS 0    
HH     RS232 - RXD 0    
II     RS232 - TXD 0    
KK     SWITCH INPUT 2    
MM     GND    
NN     AWAKE GND    
PP     AWAKE    
RR     GND    
( 3 ) The connector contacts that are not listed are not used.
Table 6
Contact Description Of Light Bar    
Connector A    
A     + Battery    
B     Ground    
C     RS232 RX    
D     RS232 TX    
Table 7
Contact Description Of Angle Sensor    
Connector A    
1     + Battery    
2     Ground    
3     Signal    
4