STABILIZER AR 2046045 - Caterpillar

Illustration 1 g02726369
Table 1
Specification for 220-6368 Flywheel Housing Gp
Item Qty Part Specification Description
Before installation of the flywheel housing, inspect the following components for any foreign materials: The front face of the flywheel housing, the two sides of the flywheel housing gasket and the rear face of the cylinder block. These components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign material. Apply ultra blue Loctite 587 to seal the joints between the cylinder block, engine oil pan, and the flywheel housing.
1 6 223-4903 Bolt Use the following procedure to tighten the bolts for the flywheel housing:
1.Tighten bolt 1 through bolt 9 in the numerical sequence as shown in Illustration 1 to 100 20 N m (75 15 lb ft) in the numerical sequence.
2. Tighten bolt 10 through bolt 23 in the numerical sequence as shown in Illustration 1 to 40 10 N m (30 7 lb ft) in the numerical sequence.
3. Again, tighten bolt 1 through bolt 9 in the numerical sequence as shown in Illustration 1 to 135 20 N m (100 15 lb ft) in the numerical sequence.
4. Again, tighten bolt 10 through bolt 23 in the numerical sequence as shown in Illustration 1 to 55 10 N m (41 7 lb ft) in the numerical sequence.
2 1 165-3932 Bolt
3 1 5J-5793 Bolt
4 7 165-3930 Bolt
5 8 5J-5794 Bolt