STARTER GP-HYD 5583900 - Caterpillar

Removal Procedure
Start By:
Remove the fuel injection pump. Refer to Disassembly and Assembly, "Fuel Injection Pump Housing and Governor - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00533637
If necessary, remove bolt (1) and the washer from the air inlet manifold.
Illustration 2 g00533639
If equipped, remove oil tube assembly (2) from the cylinder block.
Check O-ring seal (3) for wear or damage. Replace the O-ring seals, if necessary.
Illustration 3 g00533640
Remove 24 bolts (4) from engine oil cooler (5). Remove engine oil cooler (5) and gasket (6) (not shown).