STARTER G-ELEC 5M0567 - Caterpillar

Start By:a. separation of governor from fuel injection pump housing (earlier) 1. Remove ring (3) and pin (1) that hold seat (2). 2. Remove seat (2), bolt (4), washers (6) and spring (5).3. Remove the sleeve and bearing assembly from the cylinder and weight assemblies. 4. Remove ring (7) from sleeve (8).5. Remove bearing (9) and washers (10) from sleeve (8). 6. Remove valve (12) from piston (11). 7. Remove the ring (15) that holds weight assembly to cylinder (16).8. Remove weight assembly (13) from cylinder.9. Remove piston (11) and sleeve (14) from cylinder. Remove O-ring seal from sleeve (14). 10. Remove speed limiter plug (20), spring, and plunger from the governor housing (19).11. Remove torque spring assembly (17). 12. Remove bolt (21) and lock that hold lever (22) to shaft (18).13. Remove lever (22) and shaft from housing.14. Remove the seal from housing (19).15. Remove bearing (24) from the housing with tooling (A). Remove bearing (23) and the plug from the housing with tooling (B).Assemble Governor (Earlier)
1. Install bearing (24) in housing (19) to dimension (Y) or 27.25 mm (1.073 in.) from the center of guide (25) with tool group (A). Install bearing (23) in the housing to dimension (X) or 60.58 0.13 mm (2.385 .005 in.) from bearing (24) with tool group (A). Install plug (26) in the housing. 2. Install the seal in the housing with tool group (A). Install the lip toward the outside of the housing.3. Install torque spring assembly (17) on the housing. Install the lock and bolts that hold it. See the topic, Rack Setting Procedure book for the correct adjustment of the torque spring assembly. 4. Put lever assembly (22) in position in the housing. Install shaft (18) in the housing through the lever. Install the lock and bolt that hold the lever to the shaft. 5. Install speed limiter plunger (28), spring (27) and plug (20) in the housing. 6. Install the O-ring seal (27) on sleeve (14).7. Install piston (11) and the sleeve in cylinder (16). 8. Put the weight assembly (13) on the cylinder (16). Install the ring that holds weight assembly on the cylinder. 9. Install the valve (12) in the piston (11).10. Install bearing and washers (28) on sleeve (8). Install the ring that holds washers and bearing on sleeve.11. Install the sleeve assembly on valve (12). 12. Install the bolt (4) in the seat (2). Install the washers and spring in the seat.13. Put the seat in position on the valve (12). Install the pin that holds the valve, sleeve and seat together. Install the ring (3) that holds the pin in position.End By:a. connect governor to fuel injection pump housing (earlier)