STARTING MOTOR GP-ELECTRIC 3043655 - Caterpillar

Illustration 1 g01270225
From the "Setup Menu - Configuration" dialog, press the Down arrow or the Up arrow until the Valve Speed item is highlighted.
Press the "OK" key.A dialog screen appears. Refer to Illustration 2.
Illustration 2 g01270226
Press the "OK" key. The "Select Valve" dialog appears.Refer to Illustration 3.
Illustration 3 g01270227
Use the arrow keys in order to select the valve that is to be adjusted. Press the "OK" key.Lift Valve Speed
Illustration 4 g01270227
Illustration 5 g01270228
Select "Lift" from the list of valves. The "Lift Valve Speed" dialog appears.Refer to Illustration 5.
Perform one of the following actions:
Press the Up arrow or the Right arrow in order to increase the speed. Press the Left arrow or the Down arrow in order to decrease the speed.
Press "Default Set 50" in order to set the speed to the default value of 50.The valve speed is immediately updated.If the update is not successful, a dialog appears. The dialog warns that the valve speed has not been updated, and instructs you to try again. Use the Diagnostics dialog in order to check the status of the Valve Control Module and/or the Implement Valve Control ECM. Repeat the steps in "Setting Valve Speeds". Additionally, repeat Steps 1 and 2 in this section. If you still cannot change the valve speed, please contact your Caterpillar dealer.
Move the blade until the light bars indicate that the blade is above the on-grade position or below the on-grade position.
Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
Put the system in Automatic mode. The status indicator on the Valve Speed dialog indicates that the automatic controls are in the Auto state.
Watch how quickly or slowly the blade moves to the on-grade position:
If the blade moves too slowly, increase the valve speed.
If the blade moves too fast, decrease the valve speed.The blade should move quickly to the on-grade position. The blade should not overshoot the design by more than 10 mm (0.5 inch).
Put the system in Manual mode. The status indicator on the Valve Speed dialog indicates that the automatic controls are in the Manual state.
Repeat Step 2 through Step 6 until the valve speed for lift is correct for the conditions.Tilt Valve Speed
Illustration 6 g01270240
Use the up arrow or the down arrow in order to select "Tilt" from the list of valves.
Illustration 7 g01270288
Press the "OK" key.The Tilt Valve Speed dialog appears. Refer to Illustration 7.
Perform one of the following actions:
Press the Up arrow or the Right arrow in order to increase the speed. Press the Left arrow or the Down arrow in order to decrease the speed.
Press "Default Set 50" to set the speed to the default value of 50.The valve speed is immediately updated.If the update is not successful, a dialog appears. The dialog warns that the valve speed has not been updated, and instructs you to try again. Use the "Diagnostics" dialog in order to check the status of the Valve