STARTING MOTOR GP-ELECTRIC 3501614 - Caterpillar

3. Remove lifting eyebolt (1) and lay junction box (3) to the side. Reinstall the lifting eyebolt.4. Disconnect fuel ratio sensing line (2) and remove sensing line clamp retaining bolt. 5. Remove cylinder head water outlet pipe (4) and cylinder head-to-aftercooler pipe (5). 6. Remove air compressor air inlet line (9).7. Remove air compressor water inlet line (8).8. Remove water pump-to-cylinder head vent line (6).9. Disconnect water temperature sending unit (7).10. Remove the remaining cylinder head mounting bolts and washers.11. Attach a hoist and remove the cylinder head assembly-weight 200 lbs. (91 kg).Install Cylinder Head Assembly
1. Install a new and dry cylinder head gasket. 2. Attach a hoist and position the cylinder head assembly on the engine. Install the push rods, and position the rocker shaft assembly on the cylinder head.3. Coat the threads of cylinder head mounting bolts with 9M3710 Anti-Seize Compound. Install the bolts and washers, and tighten bolts in the following Step sequence: 1 Tighten all numbered bolts in numerical order to 115 lb. ft. (15,9 mkg).2 Retighten all numbered bolts in numerical order to 175 5 lb. ft. (24,2 0,7 mkg).3 Finally, retighten all numbered bolts (hand torque only) in numerical order to 175 5 lb. ft. (24,2 0,7 mkg).4 Tighten all lettered bolts in alphabetical order to 22 lb. ft. (3,0 mkg).5 Retighten all lettered bolts in alphabetical order to 32 5 lb. ft. (4,4 0,7 mkg).6 Finally, retighten all lettered bolts (hand torque only) in alphabetical order to 32 5 lb. ft. (4,4 0,7 mkg) 4. Adjust the inlet valve clearance to .015 in. (0,38 mm) and the exhaust valve clearance to .025 in. (0,64 mm).5. Connect the water temperature sending unit.6. Install water pump-to-cylinder head vent line.7. Install the air compressor water inlet line.8. Install the air compressor air inlet line.9. Install cylinder head-to-aftercooler air pipe and cylinder head water outlet pipe.10. Install fuel ratio control sensing line clamp retaining bolt and connect the fuel ratio control sensing line.11. Remove the lifting eyebolt and position junction box on the engine. Reinstall lifting eyebolt.12. Install the glow plug wiring harness.13. Fill the cooling system.concluding steps: a) install valve coverb) install turbocharger and exhaust manifold as a unit