STARTING MOTOR GP-ELECTRIC 3596475 - Caterpillar

3. Remove cotter pin and pin (1) and disconnect hydraulic control linkage (2) from the control valve spool. 4. Remove nut (4) and lockwasher to disconnect lever (5) from linkage rod (3).5. Remove four bolts and washers and remove the control linkage from the front of the tank.Install Hydraulic Control Linkage
1. Put hydraulic control linkage (1) into position in the hydraulic tank. 2. Put links (3) into position on control valve spool (2) and install a pin and a retainer to connect the hydraulic control linkage to the hydraulic control valve.3. Install four bolts and washers in the rear of the tank to hold the control linkage in place.4. Connect the lever assembly to the rod assembly with a bolt and washer.5. Put the front cover into position and install bolts and washers to hold the cover in place.6. Fill the tank with oil to the correct level. See LUBRICATION AND MAINTENANCE GUIDE.Disassemble Hydraulic Control Linkage
start by:a) remove hydraulic control linkage 1. Remove bolt and nut (3) from the lever assembly.2. Remove lever assembly (1) with two links (2) from the shaft and key. 3. Remove key (6) from the shaft and remove washers (5) and adapter (4). 4. Remove housing (7) and spacer (9) from shaft and lever assembly (8). Remove and inspect the gasket on the housing. Make a replacement if it is damaged. 5. Inspect lip type seal (10). Remove and make a replacement if needed. 6. Inspect two bearings (11) which are in each end of the housing. Remove and make replacements if needed.Assemble Hydraulic Control Linkage
Push only on the end of the bearing that has identification.
1. Use a press and tooling (A) to install the bearings in each end of housing (1). 2. Use a press and tooling (A) to install the lip type seal in the housing with the seal lip toward the inside of the housing. Put a thin layer of SAE 10W oil on the seal lip. 3. Put spacer (3) and housing (1) into position on shaft and lever assembly (2). 4. Put adapter (5) and washers (4) on the shaft. 5. Install key (7) in the shaft and put lever assembly (6) into position on the shaft and key.6. Install a bolt and nut to hold lever assembly (6) in place. end by:a) install hydraulic control linkage