STARTING MOTOR GP-ELECTRIC 3E7676 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses, and tubes. This helps prevent fluid loss and contamination of the hydraulic system.Note: Cleanliness is an important factor. Before removal, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00697649
Disconnect lines (1), (2), (3), (4), and (5) .
Illustration 2 g00697673
Attach a suitable lifting device to the piston motor.
Remove eight nuts (6) .
Remove piston motor (7) with a suitable lifting device. Weight of the piston motor is 47 kg (104 lb).
Repeat