STARTING MOTOR AS 4230064 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 7M-7456 Bearing Mount Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01440577
Typical example
Inspect the condition of the teeth and the splines of gear (7) for wear or damage. Inspect bearing (6) and bearing (8). Inspect circlip (9), and front housing (4) for wear or damage. Replace any components that are worn or damaged.
Apply a small continuous bead of Tooling (B) to inner Surface (X) of bearing (6). Place the gear shaft on a suitable support. Press on the inner race of bearing (6) until bearing (6) is against the shoulder of gear (7). Remove any excess sealant.
Apply a small continuous bead of Tooling (B) to inner Surface (Z) of bearing (8). Place the inner race of bearing (8) onto a suitable support. Press the shaft of gear (7) onto bearing (8) until the shoulder of the gear is against the bearing. Remove any excess sealant.
Apply a small continuous bead of Tooling (B) to outer Surface (Y) of bearing (6) and bearing (8). Place accessory drive housing (4) on a suitable support. Press the assembly of the gear into the accessory drive housing. Ensure that bearing (6) is against the front face of the recess in accessory drive housing (4). Remove any excess sealant.
Install circlip (9) into the groove in accessory drive housing (4). Ensure that circlip (9) is correctly positioned in the groove.