STARTING MOTOR GP-ELECTRIC 4965288 - Caterpillar

Disassembly Procedure
Start By:
Remove the transmission oil pump. Refer to Disassembly and Assembly, "Transmission Oil Pump - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Illustration 1 g00370892
Remove bolts (1) from cover assembly (2). Note: Do not remove bolts (3) at this time.
Illustration 2 g00370904
Remove manifold assembly (4).
Illustration 3 g00370907
Remove O-ring seal (5).
Remove bearings (6) from manifold assembly (4).
Illustration 4 g00371012
Remove gears (7) from body assembly (8).
Illustration 5 g00371073
Remove woodruff key (9) from the shaft.
Illustration 6 g00371078
Remove bolts (3) from cover assembly (2).
Illustration 7 g00371152
Remove cover assembly (2) from body assembly (10).
Illustration 8 g00371155
Remove O-ring seal (11).
Remove bearings (12) from cover assembly (2).
Illustration 9 g00371156
Illustration 10 g00371158
Remove gear assembly (13) and gear assembly (14).
Illustration 11 g00371160
Remove body assembly (8) from body assembly (10).
Illustration 12 g00371162
Remove O-ring seal (15).
Remove bearings (16) from body assembly (8).