STARTING MOTOR GP-ELECTRIC 4N0190 - Caterpillar

Illustration 1 g01407479
Note: Use clean engine oil to lubricate the threads of the cylinder head bolts before assembly.Use the following procedure to tighten the cylinder head bolts:
Torque for bolt (1) through bolt (20) in a numerical sequence to 270 27 N m (200 20 lb ft)
Again torque the bolt (1) through bolt (20) in a numerical sequence to 450 20 N m (332 15 lb ft).
Finally torque the bolt (1) through bolt (20) in a numerical sequence to 450 20 N m (332 15 lb ft).
Install the rocker arm assemblies onto the cylinder head.
Torque for the bolt (21) through bolt (26) in a numerical sequence to 270 27 N m (200 20 lb ft)
Again torque the bolt (21) through bolt (26) in a numerical sequence to 450 20 N m (332 15 lb ft).
Finally torque the bolt (21) through bolt (26) in a numerical sequence to 450 20 N m (332 15 lb ft).Note: Tighten the bolts only after the cylinder head bolts have been given final torque.
Torque the bolt (27) through bolt (39) to 43 7 N m (32 5 lb ft). (40) Torque for taperlock studs ... 35 5 N m (26 4 lb ft)
Illustration 2 g01017447
(A) Height of new cylinder head ... 125.00 0.25 mm (4.921 0.010 inch)
Illustration 3 g01404145
Note: Use Loctite Hi-Temp Flange Sealant on the cup plugs. (E) The cup plugs are installed into the cylinder head at the following depth. ... 4.5 0.5 mm (0.18 0.02 inch) (F) The cup plugs are installed into the cylinder head at the following depth. ... 2.0 0.5 mm (0.08 0.02 inch) (G) The cup plugs are installed into the cylinder head at the following depth. ... 0.8 0.5 mm (0.03 0.02 inch)
Illustration 4 g01417479
(41) Apply, Loctite Hi-Temp Flange Sealant on the cup plugs. Install the cup plugs in front side of each cylinder head after the cylinder head is installed on the cylinder block. (42) Use Loctite Hi-Temp Flange Sealant on the cup plugs.
Illustration 5 g01407482
Note: Lubricate the bore of the O-ring seal (44) lightly with the silicone compound prior to installation of the adapter.Note: Apply 4C-5599 Anti-Seize Compound onto the threads of the adapter prior to installation. (43) Torque for adapter ... 95 7 N m (70 5 lb ft)