AVSPARE.COM
parts catalog

STARTING MOTOR GP-AIR 5N8722 - Caterpillar


5N8722 STARTING MOTOR GP-AIR Caterpillar parts D398, D399, G399
Rating:
86
Alternative (cross code) number:
CA5N8722
5N-8722
5N8722
Caterpillar 5N8722 STARTING MOTOR GP-AIR
Weight: 0.17 pounds 0 kg.

Buy STARTING MOTOR GP-AIR 5N8722 Caterpillar genuine, new aftermarket tractor parts with delivery
GAS ENGINE, MARINE ENGINE,

Compatible equipment models: 5N8722:

GAS ENGINE  G399  
GEN SET ENGINE  D399  
INDUSTRIAL ENGINE  D398   D399  
MARINE ENGINE  Caterpillar
Number on catalog scheme:
  For full view, you need register

Information:


Table 1
Tools Needed Quantity
4C-6500 Digital Thermometer 1
or
2F-7112 Thermometer 1
6B-5072 Terminal Bushing 1
Illustration 1 g00286378
Test Location
(1) Plug.
Check the accuracy of the water temperature indicator or water temperature sensor if either of the conditions that follow are found:
A normal temperature is indicated, but the engine is too hot. A loss of coolant is found.
A hot temperature is indicated, but there is no loss of coolant. Remove the plug (1). Install the 4C-6500 Digital Thermometer or the 2F-7112 Thermometer. Also, install the 6B-5072 Terminal Bushing. A temperature indicator of known accuracy can also be used to make this check.
Personal injury can result from escaping fluid under pressure.If a pressure indication is shown on the indicator, push the release valve in order to relieve pressure before removing any hose from the radiator.
Start and run the engine until the temperature reaches the desired range according to the test thermometer. If necessary, put a cover over part of the radiator and cause a restriction of the coolant flow. The reading on the water temperature indicator should agree with the test thermometer within the tolerance range of the water temperature indicator.Water Temperature Regulator Test
Remove the regulator from the engine.
Heat water in a pan until the temperature is 92°C (198°F). Stir the water in the pan. This will distribute the temperature throughout the pan.
Hang the water temperature regulator in the pan of water. The water temperature regulator must be below the surface of the water. The water temperature regulator must be away from the sides and the bottom of the pan.
Keep the water at the correct temperature for ten minutes.
After ten minutes, remove the water temperature regulator. Immediately, check the distance of the opening of the water temperature regulator. The distance must be a minimum of 10.4 mm (.409 inch).
If the distance is less than 10.4 mm (.409 inch), make a replacement of the water temperature regulator.


Parts starting Caterpillar catalog:

3T8948 STARTING MOTOR GP-ELECTRIC
3408, 3408B, 3412, 3508, 3512, 3516, D379, D379A, D379B, D398, D398A, D399, D4H, G3516, G379, G398, G399
6T0640 STARTING MOTOR GP-ELECTRIC
245, 3406, 3406B, 3408, 3408B, 3412, 3508, 3512, 3516, 621E, 623E, 631D, 631E, 633D, 637D, 637E, 639D, 641B, 651E, 657E, 768C, 769C, 772B, 773B, 834B, 988B, 992C, D379, D379A, D379B, D398, D398A, D398...
5L5353 STARTING MOTOR AS
3408, 3412, 641B, 650B, 657B, 666B, 772, 772B, 773, 773B, 992, 992C, D342, D342C, D343, D346, D349, D379, D379A, D379B, D398, D398A, D398B, D399, G342C, G343, G379, G398, G399
3T8943 STARTING MOTOR GP-ELECTRIC
3408, 3412, 3508, 3512, 3516, D379, D379A, D379B, D398, D398A, D399, D4H, G3516, G379, G398, G399
6N9677 STARTING MOTOR GP-ELECTRIC
3406, 3408, 3412, 3508, 631D, 633D, 637D, 639D, 768C, 769C, 772B, 773B, 983B, 988B, 992C, D342, D349, D353C, D379, D379A, D379B, D398, D398A, D398B, D399, G379, G398, G399
8L6205 STARTING MOTOR AS-ELECTRIC
3512, D379, D379A, D398, D398A, D399, G379, G398, G399
3T2774 STARTING MOTOR GP-ELECTRIC
D379, D379A, D379B, D398, D398A, D398B, D399, G379, G398, G399
6N0424 STARTING MOTOR GP-ELECTRIC
D379, D379A, D398, D398A, D399, G379, G398, G399
3T8954 STARTING MOTOR GP-ELECTRIC
3508, 3512, 3516, D379, D379A, D398, D398A, D399, G3508, G3512, G3516, G379, G398, G399
4N3349 STARTING MOTOR GP-ELECTRIC
3406, 3408, 3412, 641B, 650B, 657B, 666B, 772, 773, 992, D342, D342C, D346, D349, D353C, D379, D379A, D398, D398A, D399, D44B, D550B, G342C, G379, G398, G399
3T2785 STARTING MOTOR GP-ELECTRIC
3406, 3408, 3412, 3508, 3512, 3516, 641B, 657B, D349, D353C, D379, D379A, D379B, D398, D398A, D398B, D399, G342C, G379, G398, G399
3T8944 STARTING MOTOR GP-ELECTRIC
D379, D379A, D379B, D398, D398A, D398B, D399, G379, G398, G399
8L5938 STARTING MOTOR ASSEMBLY
D342, D342C, D343, D346, D348, D353C, D379, D398, D399
3497025 STARTING MOTOR GP-AIR
3612, 3616, C280-12, C280-16
3T8954 STARTING MOTOR GP-ELECTRIC
3508, 3512, 3516, D379, D379A, D398, D398A, D399, G3508, G3512, G3516, G379, G398, G399
6V4940 STARTING MOTOR GP-ELECTRIC
1673C, 3306, 3306B, 3306C, D4H, D4HTSK II
5N8717 STARTING MOTOR GP-AIR
D379, D379A, D398, D398A, G379, G398
4P0366 STARTING MOTOR GP-ELECTRIC
3606, 3608, G3606, G3606B, G3608
8N7253 STARTING MOTOR GP-ELECTRIC
3508, 3508B, 3508C, 3512, 3512B, 3512C, G3508, G3512
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.