STATOR- 4568367 - Caterpillar

start by:a) remove final drive gears, idler pinions and bearings 1. Remove ring (1) and pin (2) from the spanner nut.2. Loosen the spanner nut with tool (A) until there is a distance of .125 in. (3.2 mm) between the nut and the steering clutch case.
Do not remove the spanner nut from the sprocket shaft until the shaft is loosened with tooling (B) or (C). The nut will hold the shaft when it is loosened from the taper in the steering clutch case.
Tooling (B) is used to remove a standard size sprocket shaft. Tooling (C) is used to remove the sprocket shaft from a Low Ground Pressure machine.3. Install tooling (B) to remove a standard size sprocket shaft as follows: a) Install the 5P4183 Adapter (6) on the end of the sprocket shaft. Install the 5P4181 Extension Adapter (4) and the 7M9772 Pin (5) in the 5P4183 Adapter as shown.b) Install the 7M9773 Adapter (3) on the extension adapter. 4. Install the 9H3992 Head (7) on the cylinder group. Install the 7M9774 Adapter on the end of the cylinder. Put 5S1430 Sleeve (9) in position over the sprocket shaft as shown. Put the cylinder group in position on the sleeve and install the 7M9772 Pin (8). Make sure the pin goes through the 7M9774 Adapter and 7M9773 Adapter.5. Install tooling (C) to remove the sprocket shaft from a Low Ground Pressure machine as follows: a) Install the 5P4183 Adapter (11) on the end of the sprocket shaft. Slide the 5S1430 Sleeve (10) over the sprocket shaft. b) Install the 9H3992 Head (13) on the cylinder group. Install the 7M9774 Coupling (14) on the end of the cylinder group. Put the cylinder group in position on the sleeve. Install the 7M9772 Pin (12) through the coupling and adapter.c) Fasten a hoist to tooling (B) or (C) and loosen the sprocket shaft. Remove tooling (B) or (C). Remove the spanner nut from the sprocket shaft. Fasten a hoist to the