STATOR AS 7T6418 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Loctite 2431 1
B 1U-6396 O-Ring Assembly
Compound 1
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01532174
If necessary, follow Step 1.a through Step 1.g in order to Install mounting bracket (20) to the engine block.
Ensure that mounting bracket (20) is clean and free from wear or damage. If necessary, replace the mounting bracket.
Position mounting bracket (20) onto the engine block. Note: The bracket should be supported until the bolts have been Installed.
Install bolt (21), bolts (22), and bolt (23).
Install bolts (24), and bolt (25). Note: Ensure that all bolts of different lengths are installed in the correct positions. Ensure that all brackets for tube assemblies are installed in the correct positions and in correct orientation.
Tighten bolt (21) and bolts (22) to a torque of 22 N m (16 lb ft).
Tighten bolt (23), bolts (24) and bolt (25) to a torque of 44 N m (33 lb ft).
Install the heat exchanger. Refer to Disassembly and Assembly, "Heat Exchanger - Install".
Illustration 2 g01618830
Ensure that the cross over pipe (14) and elbow connections (17) are clean and free from restriction. Ensure that the cross over pipe and elbow connections is free from wear or damage. If necessary, replace any components that are worn or damaged.
Install a new O ring seal (19) (not shown) to the flange of elbow connection (17).
Apply Tooling (A) to bolts (18). Position the elbow connection onto the inlet manifold. Loosely install bolts (18) to elbow connection (17).
Apply Tooling (B) to a new O ring seal (15) and to a new O ring seal (16).
Install O ring seal (16) to elbow connection (17). Install O ring seal (15) to the cross over pipe (16).
Illustration 3 g01783034
Illustration 4 g01532115
Ensure that the aftercooler is clean and free from restriction. Ensure that the aftercooler is free from wear or damage. If necessary, replace any components that are worn or damaged.
Attach a suitable lifting device to aftercooler (10). The weight of aftercooler (10) is approximately 17 kg (35 lb).
Position aftercooler (10) onto the cross over pipe (14) and elbow connections (17). Ensure that O ring seals are correctly seated into the aftercooler and the elbow connections.
Install bolts (9), bolts and washer (11) to aftercooler (10). Note: The aftercooler should be supported until the bolts have been Installed.
Tighten bolts (9), bolts and washer (11) to a torque of 44 N m (33 lb ft).
Tighten bolts (18) for elbow connection (17) to a torque of 22 N m (16 lb ft).
Connect hose (13) to aftercooler (10) and the heat exchanger. Tighten hose clamps (12) securely.
Connect hose (7) to aftercooler (10). Tighten hose clamps (8) securely.
For a sea water cooled engine,