STEERING GP 5088834 - Caterpillar

Removal Procedure
Start By:
Remove the fuel injection lines and leak off rail. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install" for the correct procedure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03341715
Use a deep socket in order to remove fuel injector (1) from cylinder head (3).
Remove seat washers (2) from cylinder head (3).
Cap fuel injector (1) and plug cylinder head (3) immediately.
If necessary, repeat Step 1 through Step 3 in order to remove remaining fuel injector (1) from cylinder head (3). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 239-3312 Hyloma Universal Sealing Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g03341716
Clean the bore for the fuel injector in the cylinder head. Ensure that no debris enters the cylinder. Clean the threads on the body of the fuel injector.
Install a new seat washer (2) into the bore for the fuel injector in cylinder head (3).
Apply a bead of Tooling (A) to the first two threads of the fuel injector that engage into the cylinder head. The bead should have a diameter of 2 mm (0.08 inch) and a length of 6 mm (0.25 inch). Note: Ensure that Tooling (A) does not cover the body of the fuel injector below the threads.
Install fuel injector (1) into cylinder head (3).
Use a deep socket in order to tighten fuel injector (1) to a torque of 64 N m (47 lb ft).
If necessary, repeat Step 1 through Step 5 in order to install remaining fuel injector (1) from cylinder head (3). End By:
Install the fuel injection lines and leak off rail. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install" for the correct procedure.