STEM ASSEM. (45 degrees) 5S9591 - Caterpillar

Engine: 3512C (S/N: LLK1-UP; LN51-UP; LD91-UP; LLA1-UP)Introduction
This Special Instruction contains information for the installation of the "loose ship" panel for 3512C and 3512C HD land drilling application. The panel will house either an EMCP4.3 or an EMCP4.4. The information in this publication focuses on installing the new generator and engine components.Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures can result in personal injury. The following procedures should also be observed.
Table 1
Related Publications for Reference    
Media Number    Publication Type    
UENR1210     Systems Operation Troubleshooting Testing and Adjusting (EMCP4.3/4.4)    
LEBE0007     Application and Installation Guide (EMCP4.3/4.4)    
SEBU9019     Operation and Maintenance Manual (for drilling)    
KENR9744     Troubleshooting (for Drilling)    
REHS9106     Integrated voltage regulator (IVR)    
RENR7941     Specifications Systems Operation Testing and Adjusting for Cat® Digital Voltage Regulator (CDVR)    
REHS7339     Installation Procedure for Product Link PLE640 Systems    
LEHE0449     Technical information for the excitation module EM10.    
LEHE0450     Technical information for the excitation module EM15.    Note: The EMCP panel does not come with a mounting bracket. A mounting bracket must be fabricated. Refer to the ECMP publication Application and Installation Guide, LEBE0007 for best mounting practices. Modifying the old mounting location brackets is not acceptable for mounting of the new panel.Note: The following instructions will allow the EMCP to be configured properly if the following configuration is true. The engine must be configured for remote start and stop as described in the ""Remote Start"" section of this publication. If the configuration is not the same as described, refer to the Application and Installation Guide, LEBE0007 to ensure the proper configuration.Use the latest version of Cat ET. The current version of Cat ET is "2014B".
Illustration 1 g03736689
Typical example of an installed unit
Illustration 2 g03737964
Typical example of a multi unit installation.Important Safety Information
Do not perform any procedure in this Special Instruction until you have read this Special Instruction and you understand this information. Use only proper tools and observe all precautions that pertain to the use of those tools. Failure to follow these procedures may result in personal injury. The following procedures should also be observed.Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and