STEP AS 1949214 - Caterpillar

Illustration 1 g00104593
(3) ON switch
(4) OFF switch The electric refueling pump pumps fuel into the fuel tank.
Do not continuously operate the refueling pump for more than 30 minutes. Do not operate the refueling pump more than a few seconds without fuel. Pump damage can result.
On - Push switch (3) in order to activate the refueling pump.
Off - Push switch (4) in order to deactivate the refueling pump.
Illustration 2 g00102657
(1) Cap
(2) Suction hose
Remove cap (1) from the fuel tank.
Properly insert the free end of suction hose (2) into a container of fuel.
Illustration 3 g00102658
(1) Cap
(3) ON switch
(4) OFF switch
(5) Level gauge
Push switch (3) in order to supply the fuel to the tank. When the tank is full, the pump stops refueling. Note: Look at level gauge (5) in order to determine the fuel level.
After refueling, install cap (1) to the fuel tank.
Illustration 4 g00102659
(2) Suction hose
(6) Bar
(7) Strip
Make sure that excess fuel is drained from suction hose (2) before storing the suction hose.
When you store suction hose (2), wind the hose on bar (6). Hold the hose end in place with strip (7).
To prevent hose damage, do not coil the hose in a tight radius.
Close the cover of the storage box. Excavator with Demolition Cab (If Equipped)
A special washer reservoir is installed when a demolition cab is used.
Illustration 5 g00464509When a machine is equipped with a refueling pump and a demolition cab, the refueling pump is relocated under the exterior storage box.