STICK CYLINDER GP-SEAL & 0875493 - Caterpillar

Illustration 22 g01523169
Settings: Advanced: Automatic Truck ID: Disabled screen
Illustration 23 g01593255
Changing the Automatic Truck ID screen status
Press the OK button.This action toggles the automatic truck ID between enabled and disabled.The status of the automatic truck ID changes to enabled.
Illustration 24 g01523167
Settings: Advanced: Automatic Truck ID: Enabled screen
Press the back button to return to the automatic truck ID submenu screen.Selecting An Item From the List
The display will show a list of items. Multiple items are shown on the display, but only one item may be highlighted at a time.
Select an item from a list with the up/left or down/right button to move the highlighted cursor.
Press the OK button.In the example that follows, the operator has been loading the Truck Railcar 1. The operator will now be loading Truck 3. To select a new truck, the operator must navigate to the list selection submenu.Note: Adjusting truck ID names is detailed later in this book under VIMS PC.
From the advanced configuration submenu, Press the down/right or up/left buttons until "List selection" is highlighted.
Illustration 25 g01523205
Settings: Advanced: List Selection screen
Press the OK button to enter the list selection submenu.
Illustration 26 g01523207
Settings: Advanced: Truck list screen
Press the OK button to enter the truck list screen.The current truck will be highlighted.
Illustration 27 g01593276
Truck list selection screen
Press the up/left or down/right button to highlight the desired truck.In this example, the desired truck is Truck 3.
Illustration 28 g01593279
Truck list selection screen
Press the OK button to select the desired truck.Summary of Switch Operation and Shortcuts
Illustration 29 g01607053
Buttons and Switches
(1) Store switch
(2) Reweigh switch
(3) Truck clear/zero switch
(5) Back button
(6) Up/left button
(7) Down/right button
(8) OK button
(12) Back button and up/left button
(13) Up/left button and down/right button
(14) Down/right button and OK button (1) Store switch Press and release to:
Store the truck weight, the truck ID, and the material ID
Reset the bucket weight and the truck weight to zero (2) Reweigh switch Press and release to:
Subtract the last bucket weight from the truck weight (3) Truck clear/zero switch Press this switch and hold to:
Zero the system (3) Truck clear/zero switch If the Truck Clear button is pressed:
All weight will be removed from the truck and bucket
The data will not be stored to memory (5) Back button Press and release to:
Exit the current menu
Remove the last selected character
Alternate between the weigh screen and the menu screen (6) Up/left Press and release to:
Highlight the previous menu item
Highlight the previous list selection item
Highlight the next character on the left side.
Highlight the action item on the left side (7) Down/right button Press and release to:
Highlight the next menu item
Highlight the next list selection item
Highlight the next character on the right side
Highlight the action item on the right side (8) OK button Press and release to:
Enter a highlighted menu.
Acknowledge an event
Acknowledge a diagnostic
Select the highlighted list selection item
Select the highlighted character
Select the highlighted action item (12) Back button and up/left button Press simultaneously to:
Enter the simple calibration update screen (13) Up/left button and down/right button Press simultaneously to:
Enter the weigh mode from any menu or from any screen (14) Down/right button and OK button