STICK GP 1323010 - Caterpillar

Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00777037
Attach a lifting strap and a hoist to stack assembly (1). Remove two bolts (2) and stack assembly (1). The weight of the stack assembly is 20 kg (44 lb).
Illustration 2 g00777038
Remove hose assemblies (3) and (5) from motor (4) .
Illustration 3 g00777039
Attach a lifting strap and a hoist to duct assembly (6) and housing (7). Remove eight bolts (8). Remove duct assembly (6) and housing (7) as a unit. The weight of the duct assembly and housing is 36 kg (80 lb).Installation Procedure
Illustration 4 g00777039
Clean the bottom of duct assembly (6) and the machine surface. Apply a bead of 4C-9502 Gasket Sealant on the bottom of duct assembly (6) .
Use a lifting strap and a hoist to position duct assembly (6) and housing (7) as a unit.
Illustration 5 g00777038
Install hose assemblies (3) and (5) on motor (4) .
Illustration 6 g00777037
Use a lifting strap and a hoist to position stack assembly (1) on the housing and install two bolts (2) .