STICK GP-EXTENDABLE 1595035 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 138-7573 Link Bracket 2 Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly , " Hydraulic System Pressure - Release". Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the oil from the swing drive into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Swing Drive Oil - Change".
Illustration 1 g01339124
Remove guards (1).
Illustration 2 g01344378
Install Tooling (A) onto the hydraulic tank . Attach an air supply hose onto Tooling (A). Apply 276 414 kPa (40 60 psi). This procedure will pull a vacuum on the hydraulic system.
Illustration 3 g01344326
Disconnect hose assemblies (2).
Illustration 4 g01344327
Disconnect harness assembly (3). Remove clip (4).
Illustration 5 g01340842
Attach Tooling (B) and a suitable lifting device to swing motor (5). The weight of swing motor (5) is approximately 68 kg (150 lb). Remove bolts (6). Remove swing motor (5). Remove Tooling (A).