AVSPARE.COM
parts catalog

STICK & BEARING AS 2444236 - Caterpillar


2444236 STICK & BEARING AS Caterpillar parts 324D, 324D FM, 324D L, 324D LN
Rating:
26
Alternative (cross code) number:
CA2444236
244-4236
2444236
Caterpillar 2444236 STICK & BEARING AS

Buy STICK & BEARING AS 2444236 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR,

Compatible equipment models: 2444236:

EXCAVATOR  324D   324D FM   324D L   324D LN   Caterpillar
Number on catalog scheme: 8
 
  For full view, you need register

Information:


Illustration 1 g02157115
Right brake solenoid circuitThis diagnostic code is associated with the right brake solenoid. The FMI 06 means that the ECM has determined that the current of the solenoid is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. ECM failure is unlikely. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0690 FMI 06 is active before performing this procedure.Note: Use a calibrated 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The diagnostic code will be logged into memory and the following actions will occur:
Traction control system (TCS) will be disabled.
Automatic retarder control (ARC) will be disabled.
Rear brake pilot supply will be turned off.Note: A short to battery will cause the park and secondary brakes not to function properly when there is accumulator pressure or the engine is running. If this condition exists, take care operating the machine. Chock the wheels and use the service brake to stop the vehicle while there is brake system pressure. Test Step 1. CHECK THE SOLENOID.
Turn the disconnect switch and the keyswitch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the harness. Expected Result:CID 0690 FMI 06 changes to CID 0690 FMI 05 when the solenoid is disconnected.Results:
YES - CID 0690 FMI 06 changes to CID 0690 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid may have failed. Repeat this test "CHECK THE SOLENOID" to verify the solenoid failure. Replace the solenoid.STOP
NO - CID 0690 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND.
Turn the keyswitch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the harness.
Disconnect the harness connector from the ECM.
At the harness connector, measure the resistance from the signal contact J1-62 (wire 775-BR) to all contacts that are used in the harness connectors for the ECM. Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5000 ohms. There is a short in the harness. The short is between J1-62 (wire 775-BR) and the circuit with the low resistance measurement.Repair: Repair or replace the harness. STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the keyswitch to the ON position.
Operate the machine.
Check the status of the CID 0690 FMI 06. Expected Result:The CID 0690 FMI 06 is not active. Results:
NO - CID 0690 FMI 06 is active. The diagnostic code has not

Caterpillar parts catalog:

Caterpillar parts catalog
324D & 324D L Excavators CJX00001-UP (MACHINE) POWERED BY C7 Engine
324D L & LN Excavator EJC00001-UP (MACHINE) POWERED BY C-7 Engine
324D L Excavator T2D00001-UP (MACHINE) POWERED BY C-7 Engine
324D L Hydraulic Excavator JJG00001-UP (MACHINE) POWERED BY C-7 Engine
324D FM JKR00001-UP (MACHINE) POWERED BY C7 Engine
324D L Excavator LAB00001-UP (MACHINE) POWERED BY C7 Engine
324D & 324D L Excavators JZR00001-UP (MACHINE) POWERED BY C7 Engine
324D & 324D L Excavators JAT00001-UP (MACHINE) POWERED BY C7 Engine
324D L Excavator PYT00001-UP (MACHINE) POWERED BY C7 Engine
324D L Excavator GPK00001-UP (MACHINE) POWERED BY C7 Engine


Parts stick Caterpillar catalog:

2909246 STICK & BEARING AS
324D, 324D FM, 324D L, 324D LN
2909258 STICK & BEARING AS
324D, 324D L, 324D LN, 326D L
2368410 STICK & BEARING AS
324D, 330D, 330D L, 330D LN, 336D, 340D L
2417328 STICK & BEARING AS
323D L, 323D LN, 323D SA
2417313 STICK & BEARING AS
320D, 323D L, 323D LN, 323D SA
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.