STICK & BEARING AS 2909246 - Caterpillar

2909246 STICK & BEARING AS Caterpillar parts 324D, 324D FM, 324D L, 324D LN

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2909246
290-9246
2909246

Weight: 2000 pounds 907 kg.

Buy STICK & BEARING AS 2909246 Caterpillar genuine, new aftermarket tractor parts with delivery
EXCAVATOR, MOBILE HYD POWER UNIT,

Compatible equipment models: 2909246:

EXCAVATOR 324D 324D FM 324D L 324D LN

MOBILE HYD POWER UNIT Caterpillar

Number on catalog scheme: 9

Caterpillar 2909246 Parts scheme STICK & BEARING AS

For full view, you need register

Information:

Personal injury or death can result if spilled fuel ignites. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.To help prevent possible injury, turn the battery disconnect switch to the OFF position when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Do not fill fuel filters with fuel before installing them. The fuel will not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts. The fuel system should be primed prior to starting the engine.
Park the machine on a level surface and stop the engine. Make sure that the transmission control is in the PARK position.
Illustration 1 g01259298
View of the back side of the fuel tank
Close fuel shutoff valve (1).
Illustration 2 g02713421
Secondary fuel filters (2) are located on the right side of the engine. Remove the filter elements from the base. Properly discard the used elements.
Clean each filter mounting base. Make sure that all of the former seal is removed.
Lubricate the sealing surfaces of the new filter elements with clean diesel fuel.
Install the filters by hand. Tighten the filter elements until the sealing surfaces contact the base. Tighten the filter elements for an additional 3/4 of a turn. There are rotation index marks on each filter element. These marks are spaced 90° or 1/4 turn from each other. Use the marks as a guide when you tighten the filter elements.
Open the fuel shutoff valve.
Prime the fuel system. Refer to the Operation and Maintenance Manual, "Fuel System - Prime".
Start the engine and inspect the filters for leaks. Make any necessary repairs.