STICK & BEARING AS 3150867 - Caterpillar

"Implement Valve Solenoid Calibrations (Pressure - Based)"
Personal injury can result from hot oil spray.Make sure all attachments have been lowered, oil is cool and the pressure has been released from the hydraulic system before removing any components or lines.Be sure there is no pressure in the tubing before it is disconnected from the fitting.Do not allow hot oil or components to contact skin.
Required Tools
Illustration 2 g01436814
Tooling (A)
Table 1
Required Tools    
Tool    Item    Part Number    Description    Qty    
A     A1     221-3405     Pressure Sensor Gp     1    
A2 301-7445     Coupler     1    
A3 3J-1907     O-Ring Seal     1    Calibration Procedure
This calibration requires tool (A) in order to calibrate the initiation current for each of the implement circuits. Tool (A) is a pressure sensor that is connected to the outlet pressure port for the implement pump. The test checks the amperage that is required in order to produce pressure that is above the stand by pressure in the implement system. The test determines the initiation current that is needed in order to start the actuation of each of the individual circuits in the machine software.These calibration procedures are available for the following solenoids:
MP Bucket Solenoids (if equipped)
Ripper Solenoids (if equipped)
Illustration 3 g01958748
Remote pressure taps on 973D (S/N: LCP1-108)
Illustration 4 g01565853
Remote pressure taps on 973D (S/N: LCP109-Up)
Connect tool (A) to port (E1) and pressure tap (R2) .
Illustration 5 g01639114
Connect Cat ET to port (E3) .
Illustration 6 g01438304
Follow the steps in Cat ET.Note: The option for "Implement Valve Solenoid Calibrations (Pressure- Based)" will only appear if tool (A) is hooked up properly before turning on Cat ET."Operator Control Calibrations (Implement)"
This calibration associates a duty cycle to a given lever position for the following components:
Single Lever Control
Dual Lever Control
Ripper Lever Control (if equipped)
MP Bucket Control (if equipped)"Linkage Sensor Claibration"
Sensor calibrations allow the ECM to determine the correct position of the appropriate cylinders. The sensor calibration will set the minimum and the maximum of the cylinder travel.To perform a sensor calibration, select the specific solenoid in the Cat ET screen and follow the displayed directions. Calibration procedures are available for the following cylinder positions:
Illustration 7 g01442102
Bucket Raise
Bucket Lower
Bucket Tiltback
Bucket Dump"Implement Valve Solenoid Calibrations (Visual)"
Illustration 8 g01441679
The bucket is moved by the lever and recorded in Cat ET by the operator when the bucket actually moves. Calibration procedures are available for the following solenoids:
Illustration 9 g01441680
Bucket Raise Solenoid
Bucket Lower Solenoid
Bucket Tiltback Solenoid
Bucket Dump Solenoid
MP Bucket Solenoids (if equipped)
Ripper Solenoids (if equipped)