AVSPARE.COM
parts catalog

STICK AS 3236923 - Caterpillar



3236923 STICK AS Caterpillar parts STICK
Rating:
61
Alternative (cross code) number:
CA3236923
323-6923
3236923
Caterpillar 3236923 STICK AS

Buy STICK AS 3236923 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Start By:
Open rotor drive belt enclosure door.Removal Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes to help prevent fluid loss and keep contaminants from entering the system.
Drain the hydraulic oil. Refer to "Operation and Maintenance Manual" , Hydraulic System Oil - Change for proper procedure.
Illustration 1 g06091160Note: Some items have been removed for photo clarity.Note: Make note of the location and routing of the following hose assemblies to aid in the assembly process.
Disconnect all hose assemblies (1) from the bottom of hydraulic oil tank (2).
Illustration 2 g06091179
Remove bolt (3).
Illustration 3 g06091246
Disconnect hose assembly (4) and hose assembly (6).
Remove two bolts (5).
Illustration 4 g06091268
Disconnect harness assembly (9).
Remove two bolts (8) and remove two bolts (11).
Place fuel water separator (7) and hydraulic oil filter (10) out of the way.
Illustration 5 g06091283
Remove harness assembly (12) and harness assembly (13) from hydraulic oil tank (2).
Illustration 6 g06091296
Remove four bolts (14). Place harness assembly (15) out of the way.
Illustration 7 g06091308
Attach a suitable lifting device to hydraulic oil tank (2). The weight of hydraulic oil tank (2) is approximately 109 kg (240 lb)
Illustration 8 g06091350
Remove four bolts (18). Remove ten bolts (16).
Remove panel (17).
Illustration 9 g06091354
Remove two bolts (19). Remove hydraulic oil tank (2).Installation Procedure
Install hydraulic oil tank (2) in the reverse order of removal.


Parts stick Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.