STICK GP-HOE 3905606 - Caterpillar

(1) Heat bearing before installation to a maximum temperature of ... 149°C (300°F)Do not allow the bearing to touch the bottom or sides of the heater.1W8582 or 1W8581 (Left hand front - to the front)
(1) Seal. Put a small amount of clean engine oil on the lip of the seal for assembly.(2) Bearing. Put clean engine oil on the bearing as lubricant for assembly.(3) Tighten bolts in drive gear to a torque of ... 30 3 N m (22 2 lb.ft.)(4) Put 5P3413 Pipe Sealant on the threads of the studs at assembly.(5) O-ring seal. Put a small amount of clean engine oil in the bore for the O-ring seal at assembly.7N8877, 1W6411 (Right hand front)
(1) Install dowels to a dimension of ... 9.7 0.8 mm (.38 .03 in.)(2) Seal. Put a small amount of clean engine oil on the lip of the seal at assembly. Install the seal with the lip toward the bearing as shown.(3) O-ring seal. Put a small amount of clean engine oil in the bore for the O-ring seal at assembly.