STOP 2P4484 - Caterpillar

4-Point Harness Adjustment
Each operator should make sure that the correct adjustments are made to insure a correct fit of the harness.Step 1
Illustration 1 g03453756Place each arm under the adjacent shoulder strap.Step 2
Illustration 2 g03453778Pull upward on the orange tabs to loosen belt.Step 3
Illustration 3 g03453805Buckle the lap belt. Fasten the seat belt catch into the buckle . Make sure that the seat belt is placed low across the lap of the operator.Step 4
Illustration 4 g03453821Pull black strap ends to snug belt across hips and pelvis. The buckle should be centered and the shoulder belts straight.Note: If buckle rides up tighten lab belt. Make sure that the seat belt is placed low across the lap of the operator.Releasing Harness
Push release button on buckle. This action will release the lap belt.
Remove arms from under adjacent shoulder straps. Sternum Strap (If Equipped)
Illustration 5 g03453859
(1) Strap clip
(2) Quick Release Buckle w/ Strap
(3) Length Adjustment
(4) Emergency Breakaway Install sternum strap clips (1) onto the shoulder belt webbing so the center bar is on the inside of the belt.
Illustration 6 g03453866
Insert clip into buckle to fasten Sternum strap.
Use length adjustment (3) to properly adjust the length of strap for a correct fit.Note: Sternum strap should be adjusted so the belts fall smoothly and is not loose.
Illustration 7 g03453876
Pull Quick release (2) to release.