STRAINER- 5142783 - Caterpillar

Bucket Close (9) - Move the joystick to this position to close the bucket or the work tool.HOLD (10) - When you release the joystick from any position, the joystick will return to the HOLD position. Movement of the structure will stop.
Illustration 23 g06264115
Seat facing to the side and seat facing rear (hoe facing)
With the seat facing to the side or seat facing rear (hoe facing), the Hoe functions are available and the joysticks will operate as shown in Illustration 23.
Boom Lower (11) - Move the joystick to this position to lower the boom.
Stick In (12) - Move the joystick to this position to move the stick inward.
Boom Raise (13) - Move the joystick to this position to raise the boom.
Stick Out (14) - Move the joystick to this position to move the stick outward.HOLD (15) - When you release the joystick from any position, the joystick will return to the HOLD position. Movement of the structure will stop.
LOWER (16) - Move the lever to position (16) to lower the loader bucket.
DUMP (17) - Move the lever to position (17) to empty the loader bucket.
RAISE (18) - Move the lever to position (18) to raise the loader bucket.
Rack Back (19) - Move the lever to position (19) to rack back the loader bucket.
HOLD (20) - Move the lever to position (20) to stop movement of the loader bucket. When you release the lever from any position except for the FLOAT position, the lever will return to the HOLD position.E-Stick Control (If Equipped)
Illustration 24 g06327057
Right joystick for the backhoe
STICK EXTEND (1) - Move the thumb roller to this position to extend the stick.HOLD (2) - The thumb roller will return to the HOLD position when the thumb roller is released from the STICK EXTEND position or from the STICK RETRACT position. Stick movement will stop.
STICK RETRACT (3) - Move the thumb roller to this position to retract the stick.Auxiliary Control (If Equipped)
Illustration 25 g06327062
Left joystick for the backhoe
ON (1) - Move the thumb roller to this position to pressurize the hydraulic line on the right side of the machine.OFF (2) - Move the thumb roller to this position to turn off the hydraulic lines.ON (3) - Move the thumb roller to this position to pressurize the hydraulic line on the left side of the machine.Note: The operation of the controls will vary depending on the work tool. While you operate the machine and the work tool slowly in an open area, check the operation of all controls for the work tool.