STRAP-CABLE 0341432 - Caterpillar

Illustration 1 g01147825
Apply Tooling (F) to gear and bearing (16). Apply Tooling (G) to dowel hole (15) .
Illustration 2 g01147772
Note: A locating dowel is used to align the upper frame with the undercarriage frame. Make sure that the dowel is in position in the undercarriage frame prior to installation. Make sure that pinion gear (12) is properly aligned with swing bearing (13) prior to installation.
Use a properly rated machine to pull undercarriage frame (14) under upper frame (11).
Use Tooling (C) and Tooling (D) to lower upper frame (11) onto undercarriage frame (14). Lower upper frame (11) in 6.4 mm (0.25 inch) increments.
Illustration 3 g01147601
Use Tooling (E) to install bolts (10). Tighten bolts (10) to a torque of 900 100 N m (664 74 lb ft).
Illustration 4 g01147600
Connect tube assembly (9) .
Illustration 5 g01147599
Attach a suitable lifting device to Tooling (C). The weight of Tooling (C) is approximately 227 kg (500 lb).
Illustration 6 g01147597
Remove pin (5). Remove plate (6). Reposition pin (7). Remove Tooling (B) .
Install the right side boom cylinder. Refer to Disassembly and Assembly, "Boom Cylinder - Remove and Install".
Illustration 7 g01147596
Remove Tooling (A) from stick cylinder pin (4) .
Illustration 8 g01147594
Note: Cylinders (1) were retracted during the separation procedure.
Attach a suitable lifting device to stick cylinder pin (4). The weight of stick cylinder pin (4) is approximately 54 kg (120 lb). Remove stick cylinder pin (4) from boom (2) .
Install the swivel. Refer to Disassembly and Assembly, "Swivel - Install".End By:
Install the front drive shaft and the rear drive shaft. Refer to Disassembly and Assembly, "Drive Shaft - Remove and Install".
Install the stick. Refer to Disassembly and Assembly, "Stick - Install".